Hi again. I have some problems useing "Change color" command.
- When I select color to replace by some other color, it is "Replace Color RGB(X,X,X) by RGB(X,X,X). But when I try to use Calculator and do it by myself, command RGB(0,0,0) does not work? Or even I make it 255,255,255 it maybe thinks it is R=255,255,255 G=0 B=0 or something
- When I have replaced color once, I can't change it again. Why?
- It changes color to all "my_object" objects. I only want to change one object's color.
Use GetRGB(X,X,X) if you use a calculation.
If you use "Replace color (0,0,0) by (255,255,255)" then all black areas will become white. If you later will make them red, you cannot use (0,0,0) since the areas are white.
Replace color uses the current color on the object and not the original one.
To get the current color of the object, use GetRGB("Active",x,y)
I dont think it's possible to change single objects, atleast not using active objects only...
n/a
DaVince This fool just HAD to have a custom rating
Registered 04/09/2004
Points 7998
8th May, 2006 at 20:55:41 -
Yeah, it is. If it's about duplicates of the same active object, you can spread a value of 1 in an alterable value of these objects and use those numbers as an identfication for that specific object.
Advertisement
Post Reply
Edited by the Author.
